Measuring Station; Base Station - Hama EWS-800 Mode D'emploi

• Dispose of packaging material immediately according to
locally applicable regulations.
• Do not modify the product in any way. Doing so voids the
warranty.
Warning – Batteries
• When inserting batteries, note the correct polarity (+
and - markings) and insert the batteries accordingly.
Failure to do so could result in the batteries leaking
or exploding.
• Only use batteries (or rechargeable batteries) that match
the specified type.
• Before you insert the batteries, clean the battery
contacts and the polar contacts.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries or batteries of a
different type or make.
• Remove the batteries from products that are not being
used for an extended period (unless these are being
kept ready for an emergency).
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not throw batteries in a fire.
• Keep batteries out of the reach of children.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain toxic,
environmentally harmful heavy metals.
• Immediately remove and dispose of dead batteries from
the product.
• Avoid storing, charging or using the device in extreme
temperatures and extremely low atmospheric pressure
(for example, at high altitudes).
4. Getting Started

4.1 Measuring station

• Unscrew the screw on the battery compartment (38) on the
back of the measuring station and open it.
• Insert two AAA batteries and close the battery
compartment (38) and then secure the screw again.
Note
Before use, ensure you insert the batteries in the measuring
station first and then in the base station.

4.2 Base station

• Open the battery compartment (34) and insert three
AA batteries with the correct polarity into the battery
compartment. Close the battery compartment.
5. Installation
Note – Installation
• We recommend initially placing the base and measuring
stations in the intended locations without installing
them and making all the settings described in
Operating the Base Station
• Only install the stations once the appropriate settings
have been made and a stable wireless connection is
established.
Note
• The wireless transmission range between the measuring
and base stations is up to 100 m in open spaces. Before
installation, ensure that wireless transmission will not
be disrupted by interference or obstacles like buildings,
trees, vehicles, high-voltage lines, etc.
• Before the final installation, ensure that there is
sufficient reception between the intended installation
locations.
• When installing the measuring station, ensure that it is
protected from direct sunlight and rain.
• The international standard height for measuring air
temperature is 1.25 m (4 ft) above ground.
Warning
• Buy special or suitable installation material from a
specialised dealer for wall-mounting.
• Ensure that no faulty or damaged parts are installed.
• Never apply force during mounting. This could damage
the product.
• Before mounting, ensure that the chosen wall is suitable
for the weight to be mounted, and make sure that there
are no electrical wires, water, gas or other lines at the
installation site on the wall.
5.1 Base station
• Use the base (35) to position the base station on a level
surface.
• Alternatively, you can install the basestation on a wall
using the opening (33) on the back.
5.2 Measuring station
• You can also position the measuring station on a level
outdoor surface using the base.
• We recommend installing the measuring station securely
on an outdoor wall.
• Install an anchor, screw, nail, etc. in the wall of your
choice.
• Hang up the base/measuring station using the opening
(33/39) intended for this purpose.
6.