Ega Master AQUAMaster 79902 Manuel D'instructions page 30

· Carry out risk assessment regarding dust and fume hazards and implement appropriate measures.
· Keep the working place clean.
· Keep in mind that working in certain materials may create dust and fumes causing a potentially explosive
atmosphere.
Remark: Some types of metal may have toxic coatings.
Please pay particular attention to avoid skin contact and breathing in, when working with those materials. Ask
your material supplier about special safety instructions and stick to them.
SAFETY INSTRUCTIONS FOR PREVENTION OF PROJECTILE HAZARDS
Wear impact-resistant safety goggles – This refers to the operator, as well as for the persons within the
vicinity of the machine. Assess and determine the grade of protection required depending on the individual
case. The risks to others should also be assessed at this time.
On overhead work, wear a safety helmet. If a work piece, accessories, inserted tools, or the tool itself
breaks, there is danger from high velocity projectiles.
· • Check all parts for damages before using the machine.
• Replace damaged parts immediately.
• When working on brittle material make sure that you are protected against harmful splinters.
SAFETY INSTRUCTIONS FOR PREVENTION OF ACCESSORY HAZARDS
Use only machine tools, accessories and consumables, which are recommended by the manufacturer. Make sure
choosing the correct size and the correct type. Use only accessories, which are in proper condition and do not touch
them during operation.
CAUTION – Injury due to carelessness!
If the machine is fixed to suspension equipment make sure that it is secure. Never hang the machine
onto the supply line.
Separate the machine form any external energy source before changing the machine tool or an
·
accessory.
· Avoid direct contact with the machine tool during and after use as it can be hot or sharp.
· Wear protective gloves when changing a tool or an accessory!
Notice: Defective/ inappropriate gloves can lead to injury. Only wear proper hand protection, adapted to the work
place requirements.
WARNING – Explosion hazard!
When operating the machine in areas exposed to explosion hazards, use only accessories,
respectively devices, which are ATEX approved and specified.
SAFETY INSTRUCTIONS FOR PREVENTION OF TRANSPORT HAZARDS
ATTENTION – Improper Transport, danger of life due to parts falling down!
Damage of the machine!
· Separate the machine form any external energy source before transportation.
Check that the machine is undamaged and in proper condition.
· Never carry the machine at the supply line.
Wear worker's protective shoes!
30