Conveying And Storage; Requirements For Product Use - Festo ELFA-RF 70 Notice D'utilisation

ELFA-RF
3

Conveying and storage

• Take a product weight of up to 40 kg into consideration.
• Comply with maximum permitted support clearances when attaching transportation aids
(è 12 Characteristic curves).
• Storage conditions:
– Short storage times
– Cool, dry, UV- and corrosion-resistant location.
4

Requirements for product use

Note
Malfunctions will occur if the device is not used correctly.
• Always comply with the specifications in this chapter.
• Take into consideration the legal regulations that apply to the location, as well as:
– Regulations and standards
– Regulations of testing organisations and insurers
– National specifications.
• Comply with the warnings and notices on the product and in the relevant operating instructions.
• Remove transport packaging, such as films, caps and cardboard.
The material used in the packaging has been specifically chosen for its recyclability (exception:
oiled paper = residual waste). In the case of ELFA-RF-...-P0, check the installation space of the guide
for foreign objects and remove these if present.
• Take material specifications into consideration (è 11 Technical data).
• Only use the product in its original state, without any unauthorised modifications.
• Take into consideration the ambient conditions at the location of use.
Corrosive environments (e.g. ozone) will reduce the service life of the product.
• Compare the limit values specified in these operating instructions with use in your actual applica­
tion. This applies, for example, to forces, torques, temperatures, loads and speeds.
Operation of the product in compliance with the relevant safety regulations depends on adherence
to the load limits.
• Take the tolerance of the tightening torques into consideration. Unless otherwise specified, the
tolerance is ± 20 %.
Festo – ELFA-RF – 1509b English 17