Table des Matières
Publicité
EN
TECHNICAL DATA
Minimum dynamic pressure: 0.5 bar
Maximum operational pressure: 5 bar
Recommended operational pressure: 1-5 bar
It's recommended to use a pressure reducer in case of
static pressure superior than 5 bar inside the waterpipe.
Maximum hot water temperature: 80°C
INSTALLATION, MAINTENANCE AND PRELIMINARY CHECKING PROCEDURE
In order to get your device work correctly and fine in time, must ensure compliance with the
mode of installation and maintenance described in this booklet. Relying on a qualified plumber.
Make sure that the system is free from all debris and impurities existing.
INSTALLATION
Fig. 1: Undo the screws, remove the protective carter and the temperature stop.
Fig. 2: Screw on the cover rings and fit the temperature stop. Screw the threaded ring on the
diverter and the finishing ring. Temperature calibration setting are provided at the end of the
manual.
Fig. 3: Glue the gasket on the back of the plate and fix it to the wall, sliding it over the cover
rings.
Fig. 4: Insert the support sockets into the rings.
Fig. 5: On the diverter insert the broach. Fit the handles, fixing them with the screws.
Fig. 6: Fit the handles, fixing them with the grubscrew. The illustration shows only one . Howe-
ver, all the models are fitted in the same way.
CLEANING
In order to get a correct cleaning, exclusiveny wash with soap and water, rewash and dry with
deerskin and a soft cloth. Avoid to use alcohol, solvents, solid or liquid detergents made by
corrosive or acid substances, towel made by synthetic materials, abrasive sponges, because
they could irreversibly alterate the treated surfaces.
Publicité
Table des Matières
