Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6. Locate the oven door hinge locks in the corners of the oven
door, and rotate the hinge locks toward the oven cavity to the
locked position.
7. After the door hinges have been locked, gently swing the door
upward to close. The door should not be forced closed.
8. When the hinges are properly installed and the door is closed,
there should be an even gap between the door and the control
panel. If one side of the oven door is lower than the other, the
hinge on that side is not properly installed.
See the "Remove Oven Door(s)" and "Replace Oven
Door(s)"sections.
Positioning Oven Feet for Multiple
Cabinet Cutout Heights
Single Ovens
The positioning of the oven feet allow a single oven to be installed
in a cutout height between 26
cm). Refer to the following instructions to position the feet for the
size of your cabinet cutout.
Cutout Height is Between 27
cm)
The oven feet do not need to be changed. They are positioned
correctly as received.
Go to the "Make Electrical Connection" section.
15
/
" and 29
7
/
" (68.4 cm and 74.8
16
16
5
/
" and 28
5
/
" (70.2 cm and 72.7
8
8
Cutout Height is Between 26
70.3 cm)
1. Using 2 or more people, place the oven on its back on a
covered surface.
2. Remove the foot from the right front spacer by removing the
#8-18 x
3
/
" screw.
8
NOTE: Do not remove the spacer.
A. Spacer
B. Foot
C. #8-18 x
3
/
" screw
8
3. In the same manner, remove the feet on the right rear, left
front, and left rear of the oven.
4. Using 2 or more people, place the oven in its upright position.
5. Go to the "Make Electrical Connection" section.
15
/
" and 27
11
/
" (68.4 cm and
16
16
11
Publicité
Table des Matières
