Button Function - AEG DD9996-B Additif Au Manuel D'utilisation

www.aeg.com
4
4. COnTrOls
A

Button function

1
2
3
4
5
6
7
8
9
10
Warning:
During the Opening and Closing phase the panel has a guard device that reverses the direction of
movement in the event of blockage during the movement itself. It performs a maximum of 6 attempts
before the "
movement if possible, then press and hold button 10 for 2 seconds. The panel will once again make a
maximum of 6 attempts to close or open before reverting to blocked status if movement is not successful.
In this case it will be necessary to call the Technical service Department.
B E
C D
Door Closed: Press and hold for approximately 2 seconds
to open the door, turn the motor on at speed three and
turn the lighting on at maximum intensity.Door Open: Press
briefly to turn the motor Off or On.Door Open: When
pressed and held for approximately 2 seconds turns off the
motor and the lighting, cancelling any function that may be
active and closing the door.
Decreases the working speed.
Increases the working speed.
Can only be activated with Door Open. This speed is timed
to run for 10 minutes. at the end of this time the system
will automatically return to the speed set before. suitable to
deal with maximum levels of cooking fumes.
Pressed for 5 seconds = enables/Disables the activated
Charcoal Filter alarm with motor turned off and with no
Filter alarms triggered.
Can only be activated with Door Open. starts the motor at
a speed that allows suction of 100 m3/h.
Press for 5 seconds = enables/Disables the remote
Control with motor and lights turned Off.
Can be activated with the motor on, this enables automatic
shutdown of the motor and the lighting with a 30' delay.
Press for 5 seconds = enables/Disables the Keyboard
lock with motor and lights Off, for example to clean the
Glass.
Perform a reset of the Filter saturation alarm when the
Button is pressed for approximately 2 seconds (motor +
lights = Off)
modifies the intensity of the lighting each time the Button is
pressed, with a maximum of 5 levels, accessed in cycle.
Turns the lights on and off (at maximum intensity), regard-
less of the position of the Door.
Door Closed: When pressed and held for approximately 2
seconds opens the door.
Door Open: When pressed and held for approximately 2
seconds turns off the motor and the lighting, cancelling any
function that may be active and closing the door.
" icon flashes to indicate actual blockage. At this point, remove the obstacle preventing
F
G
display
Displays the set speed.
The number of lighted segments decreases.
The number of lighted segments increases.
The indicator I flashes and all the segments on the
Display are lit.
It is disabled by pressing the Button.
led " © " flashes twice = a.C. Filter alarm activated
led " © " flashes once = a.C. Filter alarm Deacti-
vated
Displays 24 and the segments on the Display light up
one at a time in cycle from left to right.It is disabled
by pressing the Button.
motor leD bar flashes twice = remote control On
motor leD bar flashes once = remote control Off
Displays a flashing Clock symbol.It is disabled by
pressing the Button.
The leDs on the motor Bar show an animation.
after 100 hours in operation the Drop symbol is
displayed to indicate saturation of the metal Grease
Filters.
after 200 hours in operation the letter C is displayed
to indicate saturation of the activated Charcoal filters.
L
I
H