Preparing The Record Player - Teac TN-280BT Mode D'emploi

Keep the unit in standby while setting it up ( D on page 5).
1
Place it on a flat surface.
Since the heights of this unit's feet cannot be adjusted,
be sure to place it on a flat surface.
2
Install the turntable (platter).
Align the turntable (platter) with the center shaft and
install it.
Center shaft
Turntable (platter)
3
Loop the belt around the motor pulley.
The rubber belt is wrapped around the sub-platter.
Use a finger to pull the rubber belt through the round
opening and loop it around the motor pulley.
o Be careful not to let the rubber become twisted.
o Rotate the turntable (platter) several times to make
sure that it is secure.
Round opening
Motor pulley
Rubber belt
6
TN-280BT_OM_EFS_vA_CS6.indb 6

Preparing the record player

4
Place the felt mat on the turntable
(platter).
Place the mat that is included with the turntable on it
before use.
5
Install the counterweight.
Place the counterweight over the end of the tone arm
and turn it clockwise to tighten it.
Counterweight
6
Install the headshell.
Insert the headshell on the end of the tone arm and
turn the nut to secure it in place.
Nut
Headshell
Balancing the tone arm and adjusting
the stylus pressure
Counterweight
Stylus pressure adjustment ring
Center line
Anti-skating dial
Cue lever
1
Set the anti-skating dial to zero.
2
Move the tone arm clasp to the right to
release the tone arm.
Clasp
3
Lift the cue lever and shift the tone
arm to the left slightly.
4
Lower the cue lever.
5
Turn the counterweight and adjust so
that the tone arm is level.
o Remove the protective cap from the cartridge sty-
lus before adjusting.
o Be careful not to let the cartridge stylus touch the
unit.
6
Return the tone arm to its original
position, and move the tone arm clasp
to the left to lock it in place.
7
Turn the stylus pressure adjustment
ring so that the center line aligns with 0
on the scale.
o Be careful not to let the counterweight turn.
8
Turn the counterweight so that the
stylus pressure adjustment ring scale
matches the stylus pressure specified
for the cartridge.
o The stylus pressure of the included cartridge is 3.0 g.
For 3.0g stylus pressure, turn the counterweight
counterclockwise around one time completely so
that the stylus pressure adjustment ring passes 0
and then keep turning it until 0.5 aligns with the
center line. (Do not turn the ring by itself.)
9
Adjust the anti-skating dial.
Start with it set at 3 and adjust it during record playback
(page 8) to the position where the left and right
volumes are balanced.
2018/06/01 14:35