AEG DDE5960B Notice D'utilisation page 42

4.4 Activating and
deactivating the filter
notification
Filter alarm reminds to change or clean
the charcoal filter and clean the grease
filter. The filter indicator
(white) for 30 seconds if the grease filter
must be cleaned. The filter indicator
flashes (white) for 30 seconds if the
charcoal filter must be replaced or
cleaned.
Refer to filter alarm in care
and cleaning chapter.
1. Switch on the control panel.
5. CARE AND CLEANING
5.1 Cleaning the grease filter
Each filter must be cleaned at least once
a month. Filters are mounted with the
use of clips and pins on the opposite
side.
To clean the filter:
1. Pull the cover to open it.
Be careful! To prevent
accidental collapse, the
cover has two hooks on the
sides.
2. Press the handle of the mounting clip
on the filter panel underneath the
hood (1).
www.markabolt.hu
2. Make sure that the icons are turned
3. To activate or deactivate the charcoal
is turned on
3. Slightly tilt the front of the filter
Repeat the first two steps for all filters.
4. Clean the filters using a sponge with
5. To mount the filters back follow the
Repeat the steps for all filters if
applicable.
off.
filter notification touch
seconds.
If the charcoal filter
notification is activated, the
filter icon flashes (white)
five times.
If the charcoal filter
notification is deactivated,
the filter icon
(white) three times.
1
2
downwards (2), then pull.
non abrasive detergents or in a
dishwasher.
The dishwasher must be set
to a low temperature and a
short cycle. The grease filter
may discolour, it has no
influence on the
performance of the
appliance.
first two steps in reverse order.
for 3
flashes