Main Unit Parts And Functions - Teac AX-505 Mode D'emploi

Main unit parts and functions

A
A
STANDBY/ON switch
Use to put the unit into standby mode or turn it on.
B
PHONES jack
Connect headphones with a 3.5mm (1/8") stereo mini plug
here (page 9).
o This headphone amp circuit uses a four-pole connector with
independent left and right for grounding. Ordinary plugs
with 3 or 4 poles can be used.
o When headphones are connected to this unit, sound will be
output from the PHONES jack but will not be output from
the SPEAKERS terminals on the back of the unit.
Wiring illustration
L+ R+
10
B C D
L− R−
E
C
INPUT SELECTOR knob
Use to select the input source. The indicator lights for the
selected source.
D
Remote control signal receiver
This receives signals from the remote control. When operat-
ing the remote control, point it at the remote control signal
receiver.
E
Level meters
These show the output levels.
F
VOLUME knob
Use to adjust the volume. Turn right to increase and left to
decrease the volume.
The maximum volume level is 0 and the minimum
level is −∞ (negative infinity). Before setting the
STANDBY/ON switch to ON, set the VOLUME knob to
its minimum value (−∞). Failure to do so could result
in sudden loud noises that could damage speakers
and harm your hearing.
F