Features And Controls - Teac A-BX10 MKII Manuel Du Propriétaire

Features and Controls

Front Panel
Remote Control Unit
1
8
5
Certain buttons on the remote control unit
and on the front panel of the amplifier have
the same or similar functions and have the
same reference numbers.
● The power is turned on/off (standby) by
pressing the power button on the
remote control unit in standby mode.
Phono Play
The PA-B10 plug-in "balanced MM/MC
preamplifier" board is optionally
available so you can connect a
turntable to this unit.
3
Front Panel
1 power switch
When the main power switch on the rear
panel is ON:
Turn the front power switch to ON.
7
Turn it again to the Standby Position to
switch power OFF, and the LED indicator
9
glows red.
2 remote sensor
3 volume control
3
This control is used to adjust signal output
levels to the speakers.
Use the level control ( ˙ / ¥ ) buttons to
adjust the volume. The volume can be
adjusted in 1 dB units from 0 dB (minimum)
to 79 dB (maximum).
4 volume level display
The current level setting is shown on the
display.
5 input selector & indicators
Turn the selector to choose the input
source to be played (tuner, tape 1, CD,
balanced, and aux).
The input source indicator will light.
6 tape 2 monitor switch & indicator
source:For reproduction
from a source selected using the
input selector. The LED indicator
will not light.
tape: For reproduction of sound using
tape 2 monitor. The LED indicator
will light.
of sound
– 4 –
7 muting button
(on the remote control unit)
Press this to mute (0 dB) the sound from the
speakers when answering the telephone,
etc. To restore the original volume, press
the input selector buttons or level control
(˙/¥) buttons. While muting is engaged,
the volume level display shows 0 dB.
8 balance control button
This button is used for adjusting the
balance of the volume level between the
left and right channels.
Press the balance button (the balance LED
indicator will light.), then press the level
control ( ˙ / ¥ ) buttons.
The level setting is shown on the display.
The balance level can be adjusted in 1 dB
units from – 6 dB to 6 dB.
9 Tone (bass/treble) controls
These two tone controls – bass and treble –
can be used to obtain a "flat" frequency
response or a tone which suits your
individual listening preference. The bass
control adjusts low frequencies and the
treble control adjusts the high frequencies.
Press the bass (or treble) button (the bass
or treble LED indicator will light.), then
press the level control ( ˙ / ¥ ) buttons.
It is possible to adjust the bass ( or treble)
two steps down (–1 or –2) or two steps up
(1 or 2).
● If levels are not adjusted within 10
seconds, the LED indicator will turn off,
and volume can be adjusted again.