AKG WMS40 microtools TM40 Mode D'emploi page 9

2 Description
2.1 Introduction
Dear Customer:
Thank you for purchasing an AKG
product. This Manual contains important
instructions for setting up and operating
your equipment. Please take a few
minutes to read the instructions below
carefully before operating the equip-
ment. Please keep the Manual for future
reference. Have fun and impress your
audience!
2.2 Unpacking
1 TM 40 1 CA 40 1 AAA
transmitter charging size bat-
module adapter tery
Check that the package contains all the
parts listed above. If anything is missing,
please contact your AKG dealer.
2.3 Optional Accessories
CU 40 charger
2.4 Description
The TM 40 is a WMS 40 microtools
Series miniature transmitter module
specifically designed for direct connec-
tion to the D 880
C 900 , and C 5900
M
The TM 40 operates on a single fixed,
quartz stabilized carrier frequency in the
710 MHz to 865 MHz UHF band.
1 black
The color of the battery cover indicates
battery
the carrier frequency of your transmitter.
cover
, D 3700 , D 3800 ,
M M M
microphones.
M
You can replace the color code battery
cover with the supplied black replace-
ment cover.
2.5 Controls (Refer to fig. 1)
1 ON/MUTE/OFF: This slide switch
provides three positions:
ON: Power to the transmitter module
is on.
M: The signal delivered by the micro-
phone is muted while power and the
RF carrier frequency remain on. This
prevents the receiver from respond-
ing to interference from other trans-
mitters.
OFF: Power to the transmitter mod-
ule is off.
2 Battery compartment for one 1.5-V
AAA size battery (supplied).
The color of the battery compartment
cover indicates the carrier frequency
of your transmitter module:
9