Leister FUSION 2 Instructions D'utilisation page 16

Accessoires
• Only Leister accessories must be used.
Maintenance
• In case of soiling clean the air inlet (15) on the hot air blower with a brush.
• Clean the extruder nozzle (19) each time the welding shoe is replaced and remove any welding deposits (see page 15).
• Check power supply cord and plug for electrical and mechanical damage.
• Regularly clean the air hose (16).
Service and Repairs
• Have the state of the carbon brushes of the drive and hot air blower checked by your service centre after
ca. 250 hours of operation. The drive and the hot air blower switch off automatically once the minimum
carbon length has been reached.
Operating time;
• Repairs should only be carried out by authorized Leister Service Centres. They guarantee a specialised and
reliable Repair Service within 24 hours using original spare parts in accordance with the circuit diagram and
spare parts list.
Warranty
• For this tool, we generally provide a warranty in accordance with the statutory / country-specific regulations from
the date of purchase (verified by invoice or delivery document). Damage that has occurred will be corrected
by replacement or repair. Heating elements are excluded from this warranty.
• Additional claims shall be excluded, subject to statutory regulations.
• Damage caused by normal wear, overloading or improper handling is excluded from the guarantee.
• Guarantee claims will be rejected for tools that have been altered or changed by the purchaser.
16
Официальные поставки www.mikst.ru
Drive ca. 300 hours (brushes)
Hot air blowers ca. 1000 hours (brushes)