Publicité
Les langues disponibles
Les langues disponibles
JCOM1: Serial Port Connector
This connector allows you to connect the optional serial port with bracket.
2
10
1
9
JBAT1: Clear CMOS (Reset BIOS) Jumper
There is CMOS memory onboard that is external powered from a battery located on
the motherboard to save system configuration data. If you want to clear the system
configuration, set the jumpers to clear the CMOS memory.
Keep Data
(default)
Resetting BIOS to default values
1.
Power off the computer but DO NOT unplug the power cord (system under S5/
Soft-off mode)
2.
Use a jumper cap to short JBAT1 for about 5-10 seconds.
3.
Remove the jumper cap from JBAT1.
4.
Power on the computer.
EZ Debug LED
These LEDs indicate the status of the motherboard.
CPU - indicates CPU is not detected or fail.
DRAM - indicates DRAM is not detected or fail.
VGA - indicates GPU is not detected or fail.
BOOT - indicates booting device is not detected or fail.
1
DCD
3
SOUT
5
Ground
7
RTS
9
RI
2
4
6
8
10
Clear CMOS/ Reset
BIOS
SIN
DTR
DSR
CTS
No Pin
Rear I/O Panel
15
Publicité
