Network Scheme; Desktop Installation; Connecting Network Cable - Atlantis NetMaster F8PoE Mode D'emploi

3.3 Network Scheme

3.4 Desktop Installation

When installing the Switch on a desktop or shelf, the rubber feet included with the
device must be first attached. Attach these cushioning feet on the bottom at each
corner of the device. Allow enough ventilation space between the device and the
objects around it.

3.5 Connecting Network Cable

The Switch support 8 10/100M Ethernet ports and Port 1 ~ port 4 are PoE Enabled
ports, these PoE port will automatically activated when a compatible terminal is
identified, the Switch will supply power through the Ethernet port to the connected
PoE powered device (PD).
For the Legacy devices that are not yet compatible, the PoE port will not offer the
power to this device. This feature allows users to freely and safely mix legacy and
Power over LAN compatible devices on their network.
The Switch supports 10Mbps Ethernet or 100Mbps Fast Ethernet and it runs both in
half and full duplex mode using two pair of Category 5 cable.
These RJ45 ports are Auto-MDI type port. The Switch can auto transform to MDI-II
or MDI-X type, so you can just make an easy connection that without worrying if
you are using a standard or crossover RJ45 cable.
25