Raider RD-GBC10 Mode D'emploi page 36

36 www.raider.bg
between the electrodes and must be cleaned of deposits. Remove the "pipe" of the spark
plug, and pull the handle on the top and end. Under no circumstances remove "pipe" by
pulling the cord. Tailpipe can be very hot if the engine was working. Be careful not to touch
the tailpipe. With the help of key unwrap the spark plug spark plug unscrewed. Visually check
the spark plug. Dispose of the spark plug if it is apparent insulation is worn or broken or
cracked. "Check and sealing "O"-ring. If the spark plug is in excellent condition and cleans
it with a copper wire brush and screw it back into the cylinder head. Screwing in a new spark
plug, tighten an additional 1/2 turn after the spark plug up and pressed "O"-ring. Make sure
the spark plug is properly tightened. Improper tightening may cause overheating of the engine
and its failure. Use only high quality spark plugs that type.
8. Transportation and storage.
To avoid risk of fire engines have to wait to cool before motor mower to be transported.
8.1. Make sure that the storage is not wet or dusty.
8.2. Cover motor mower to prevent dust.
If necessary, repair your motor mower is best carried out only by qualified specialists in
workshops RAIDER, which used only original spare parts. This ensures safe operation of the
machine.