Raider RD-GBC10 Mode D'emploi page 34

34 www.raider.bg
4. Starting the engine.
Switch the ignition key in the starting position. If the engine is cold or ambient temperature
is low, set the choke control in the choke position. After starting the engine, wait a while until
the engine warms up gradually and go back choke control. A sure sign of the need to go back
choke control is the appearance of thick smoke from the tailpipe.
NOTE: The choke control does not close when you start the heated engine or at relatively
high temperature environment. Under these conditions, no pull choke control when you start
the engine.
4.1. Switch the ignition key in the starting position I.
4.2. Set the choke control in the choke position, if the ambient temperature is low.
4.3. At the start of the engine is likely to be obtained kick from the recoil starter. So take
your proper and stable position when pulling the hand launcher.
4.4. Gently pull hand starter, making it convenient to grasp the handle until you feel
resistance. Then pull sharply.
4.5. WARNING! Do not let the starter rope to be wound back sharply in the engine. Return
it gently to avoid damage to the starter.
4.6. After starting the engine to increase the speed with a throttle lever.
5. Working with brush cutter.
5.1. Always keep the machine with both hands.
5.2. The grass is cut down with a sideways, lateral movement.
5.3. The movement from right to left is the clearing stroke and the movement from left to
right is the return stroke.
5.4. Try to work rhythmically. Stand firmly with your feet apart.
5.5. Move forward after the return stroke and stand firmly again.