Publicité
Les langues disponibles
Les langues disponibles
Step 13:
Attaching new fence faces
38
37
38
37
Figure 18
Step 14:
Storage of shimming bars (when not in use)
21
21
Figure 19
Step 15:
Using the shimming bars
Figure 20
a.
Slide the fence face screws (part #38) into the previously drilled
holes in your new fence faces. See figure 18.
22
22
23
23
NOTE: the fence face screws may need to be tapped
with a hammer into the counterbored holes in the fence
face to fully seat them.
b.
Slide the fence face (part #37) and fence face screws into the
34
34
slots in the fence uprights (part #12 & part #34).
c.
Reattach with clamping knobs (part #22) and ¼" washers
(part #23).
MAST-R-FENCE III JOINTING
a.
Slide the shimming bars (part #33) into the shimming bar hold-
ers (part #21) until the second detent "clicks" into place.
33
33
a.
Loosen the fence face clamping knobs (part #22) on the out-
feed side until there is enough play behind the fence face to
slide the shimming bars behind.
33
33
b.
Slide the fence shimming bars (part #33) into the matching
grooves on the out feed fence upright (part #12).
c.
When sliding the shimming bars into the left hand fence upright
(part #12) match the laser engraved feed direction to the de-
sired jointing spacing. (
NOTE: DO NOT install the shimming bars past the laser
engraved STOP line.
d.
Once the shimming bar is behind the fence face, tighten the
fence face clamping knobs (part #22).
14
⁄
" or
⁄
").
1
1
16
32
Publicité
