Filling The Magazine - KMR AC/90-942C Mode D'emploi

4

Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1) with
•
each other.
Check fasteners for proper condition.
•
Put nailer carefully down in defined safe resting position (Chap.
•
3): The driving nose must point away from any person. It must
be impossible to unintendly actuate trigger and/or release
protection.
Actuate the locking lever 1 on the head piece and open the
•
head piece flap 2. Then open magazine cover 3 and set coil
plate 4 to nail length. Insert nails into magazine. Then close the
magazine cover and headpiece flap
5 Adjusting drive-in depth
Reduce pneumatic operating pressure as far as possible to
•
minimize blowback, noise and air consumption (see General
operating instructions).
Mechanical adjustment of drive-in depth:
Disconnect the tool from the compressed air supply. Turn
•
adjustment knob 1 for deeper countersunk nails clockwise. Turn
anti-clockwise to lower the nails less deeply.
6 Changing the trigger setting
Disconnect
• the unit from the compressed air supply, press button
the valve lever from the front and with the other hand set it to single
release (symbol 1 nail) or contact release (symbol with 3 nails).
Reconnect the tool to the pressure source.
7 Removing magazine residue
If necessary, grasp the tape strip that has escaped from the
•
machine during the processing of the nails and tear it off with a jerk
If necessary, sever the tape strip that emerges from the front of the
•
machine during
the processing of the nails with a light blow against a
wooden edge or with a plastic hammer on the cutting bolt 1.
Device-specific additional instructions for nailer
.
1 on
EN - 14
AC/90-942C