Filling The Magazine; Eu Declaration Of Conformity - KMR 3477 Notice D'emploi

Device-specific additional instructions for nailer
4

Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1)
•
with each other.
Check fasteners for proper condition.
•
Pull pusher 1 backwards and engage. Insert staple rod into
•
the magazine from above and push forward. Disengage the
pusher and push it forward
5 Adjusting drive-in depth
Reduce pneumatic operating pressure as far as possible to
•
minimize blowback, noise and air consumption (see General
operating instructions).
Mechanical adjustment of drive-in depth:
Disconnect the tool from the compressed air supply. Loosen
•
screw 1 on the release bracket and push release shoe 2
downwards for less recessed clamps or upwards for more
recessed clamps. Then tighten screw 1 firmly again and
connect the tool with compressed air.
6 Removing stuck fasteners from the driving channel
Disconnect the tool from the compressed air supply. Remove the
•
staples from the device. Actuate the locking lever 1 and open the
head piece flap 2. Remove jammed staples. Close the head piece
flap 1 again, connect the tool to the pressure supply and refill the
magazine with staples.
7

EU Declaration of conformity

The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
.3477
.
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 13