Installation - Assembly - Kospel EPMH Serie Mode D'emploi

Installation – Assembly
1. Bring the water system pipes and electric supply cables (observing binding norms)
to the place where the unit will be fitted.
2. Take off the unit's cover: undo the screws, slide the cover off.
3. For unit installation with the connectors facing toward the wall: screw the fittings
to the end of water pipes according to the picture below (make sure you install the
filter in the cold water inlet), install the heater to the pre-installed fittings through
the back holes and then fix the unit to the wall.
4. For unit installation with the connectors at the bottom: break open the thin plastic at
the bottom of unit's cover, screw the fittings according to the picture below (make
sure they are facing down), put the filter and connect the cold water pipe to the inlet
connector (e.g. using the flexible hoses) and hot water pipe to the outlet connector.
5. Open the cold water valve and check for leaks.
6. Connect the unit to the electric mains according to the labels, run the supply wire
through the rectangle hole at the unit's bottom.
7. Put the unit's cover back.
8. Make sure that there is no access to live parts through the holes at the back plate.
PL;DE;FR;GB;RU-060ABC_f.1097
GB
19