Installation - Assembly - Kospel EPS2 Instructions D'installation Et D'utilisation

Installation – Assembly
Venting
1. Shut off electric supplies.
2. Turn the flow on (turn the hot water tap on) in order to vent the installation until
the flow of water becomes constant and even.
3. Shut off the flow.
4. Switch on the electric supplies.
Vent the appliance every time after a decay of water.
Maintenance
1. Cut off water and electric supply to the heater.
2. Disconnect the heater from the tap set.
3. Take the filter out from the fittings at cold water inlet.
4. Clean the filter and install the filter into the former position.
5. Fix the heater on the tap set.
6. Turn the flow on and check for leaks.
7. Vent the installation (see „Venting" section).
PL;DE;FR;GB;HU-059B_f.908
1. Fix the mixer tap set on water supply pipe.
2. Connect the heater to the tap body with
nuts, gaskets and the flow reducer which is
positioned in the filter (see picture).
3. Allow water mains pressure gets to the tap.
4. Open the tap and check for leaks. Do it without
the spray- head on. Some impurities which
come from the installation may appear.
5. Vent the water installation.
6. Put the spray-head on.
7. Connect the heater to the power source
(through the installation cable box).
GB
13