Inoksan PDG102MN Manuel D'utilisation page 18

LIGHTING INSTRUCTION
• Each gas tap controls a horizontal and / or a
rowed of radios.
• First open the main gas valve,
manually burn the pilot, then burn
the burners starting from the bottom
• For the first burning operation (lower
burner), push button "1" and turn counter
clockwise from "0" to full flame position.
• For the half flame, press the button and
turn counter clockwise from "0" to the
half flame position.
• For burn the other burners, turn the burners
buttons clockwise from "0" position to full
flame position, from the lower hold down the
flame until the flame is jumped, and leave the
combustion process
To rotate the skewer, plug the appliance plug "1" into a socket
and bring the key "2" with position "I-0-II" to the postion "I" or
"II" (Right/Left rotation).
SHUTDOWN INSTRUCTION
To shutdown the appliance, turn all knobs clockwise one by
one until they are at position 0 starting with the bottom knob.
Bring motor power switch to "0".
After all the burners have been switched off, close the
main gas valve and completely cut off the gas
"Wait for 5 minutes before restarting the appliance
when you turn it off."
SAFETY PRECAUTIONS
 When the surfaces of the robax glass and storage
system cools down, use a few drops of suitable cleaner
and wipe clean with a soft cloth or paper towel.
 Rinse thoroughly with water and dry with another
paper towel or soft cloth.
4. POWER INLET
 The appliance must be supplied with 110V AC 60Hz
mains voltage.

The appliance must be grounded.
GROUNDING
WARNING : The appliance is equipped with a
three-prong (grounding) plug for your against
shock hazard and should be plugged directly into a
properly grounded three-prong receptacle. Do not cut or remove
the grounding prong from this plug .
The appliance, when installed, must be electrically grounded
in accordance with local codes, or in the absence of local
codes, with the National Electrical Code, ANSI/NFPA 70,
or the Canadian Electrical Code, CSA C22.2
directly or with high-pressure water. Otherwise you
may cause an electrical installation malfunction.
19
0
CLOSED
BURNER FULL FLAME
LEFT BURNER HALF FLAME