Inoksan PDG102MN Manuel D'utilisation page 17

Always read the instruction manual
before starting to use the appliance and
keep it for future reference when you
need it.
Manufacturer company does not accept any
responsibility for any operations performed
without following the instruction manual,
and for damages occurred against people or property
due to maintenance or technical interventions by
qualified technicians.
1. INSTALLATION
 Technical Specifications" table should be based
on when installation of the appliance, gas
connection and conversion to different gases,
electricity supplies are installed by experts in
accordance with local standards.
 Place the appliance on a bench by taking it on a
scale.
 Place the appliance under a fume hood or in an
environment where adequate ventilation can be
carried out in order to exhaust fumes and odors.
2. USER INSTRUCTION

Do not overload the appliance more then the
specified meat capacity in the chart

Controlling of the radians can be performed separately in
horizontal or vertical row, put the radians into use in
accordance with the size of the doner meat.

1d/d motor placed in the lower body rotates the
skewer in an inclined or upright position, providing
ease of homogeneous cooking and ergonomic use.
WARNING: Allow enough space around the
unit for adequate ventilation. Read all labels
on the unit and follow their instructions.
If the appliance is mounted in the immediate vicinity of
kitchen furniture, decorative coating etc., it is
recommended that they should be made of non-
combustible material; otherwise they must be coated with
non-burning thermal insulation material and fire protection
instructions must be followed carefully.
3. GAS
PEASUREMENT

"Toques and mittens" should be used while
user working.
 Gas inlet pressure must be in accordance with the
values given in the table after the gas connection.
For this purpose, a hood must be used to ensure
proper flow rate and pressure.
 Make sure the adaptation of the appliance is
carried out in accordance with the gas you will e.
If it is not appropriate, the injector must be
changed.
 All the necessary components for installation will
be provided by the manufacturer.
18
PRESSURE