MINN KOTA Talon 1810226 Instructions D'installation

Item /
Part # Description
Assembly
1 2376451 PLATE-SUPPORT, MACH, PONTOON
2 2376455 PLATE-SPANNER, SHORT, PONTOON
3 2376456 PLATE-SPANNER, LONG, PONTOON
A
Includes 2994931 BAG, ASM, PERFORM, PONTOON
4-10
4 WASHER-FLAT 5/16 SS
✖
5 BOLT 5/16-18 X 2" HHCS S
✖
6 BOLT 5/16-18 X 1-1/2" HHCS
✖
7 NUT 5/16-18 NYLOCK S/S
✖
8 WASHER-LOCK 5/16
✖
9 SCREW 5/16-18 X 1" PPH SS
✖
10 ANTI-SEIZE TUBE, 4CC, (NOT SHOWN)
✖
This part is included in an assembly and cannot be ordered individually.
✖
TOOLS AND RESOURCES REQUIRED
• Drill
• 3/8" Drill Bit
MOUNTING CONSIDERATIONS
Before mounting your Pontoon Edge Mount Kit and Pontoon
Performance Kit, give consideration to the following:
1. Because your pontoon bracket requires attaching to the
structural cross members of the pontoon frame that run parallel
to the bow and transom, Minn Kota requires mounting your
Talon on either the bow or the transom of your pontoon, and
does not endorse mounting on the side of the pontoon. Side
mounting will void your product warranty. See figure for a
complete typical installation.
2. Some pontoons use aluminum sheeting underneath the deck.
Accessing the structural cross members of the pontoon frame
beneath will require the removal of this aluminum sheeting in
order to install the Pontoon Edge Mount Kit and Pontoon
Performance Kit. Minn Kota recommends contacting the
pontoon manufacturer or dealer for installation.
3. Pontoons vary between the types of edge trim used along the
outer perimeter of the pontoon deck. In some cases the profile
is raised which may prevent the pontoon bracket from sitting all the way against the face of the pontoon edge trim. It may be
necessary to shim or cut away around these areas to securely complete the installation.
4. The Talon Tilt Bracket - 1810222 is recommended for adjustable deck support to accommodate for low clearances and boat storage.
Reference the Accessories section of these instructions for more details.
©2017 Johnson Outdoors Marine Electronics, Inc.
PONTOON PERFORMANCE KIT
Qty.
1
1
1
1
1
8
2
2
4
8
8
1
• Ratchet (or Socket) Wrench
• ½" Socket
Complete Typical Installation
This Talon Pontoon Performance Kit - 1810226, is designed to
provide additional deck support for pontoons with high powered
engines (125 HP+), or where additional deck support is
needed. Failure to follow recommended installation procedures,
or any damages resulting from misuse or improper installation,
may void your product warranty.
5
A
2
3
• ½" Box Wrench
• #3 Phillips Bit
CAUTION
1810226
6
4
7
9
8
minnkotamotors.com | 1