Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
HU 0059
70l MIXED WASTE OIL DRAINER
Symptom of failure
Damage/cracks of modular
cylinder
Cylinder explosion
Oil leakage from cylinder oil
ejection valve
Oil leakage in the connecting part
of oil tray and lifting pole
Oil leakage found inside the lifting
pole connector where connects to
oil tray
possible causes of problem
Been extracting uid that contains
corrosive liquid and oil additive.
gasoline, brake uid, synthetic/half
synthetic oil etc.
Tools were used to tighten or loosen
cylinder during mount/demounting.
Over high oil temperature (normal
40-60°C)
Serious impact was made during
operating and relocating
Cylinder oil ejection valve was
opened while draining waste oil
from oil tank, positive pressure
inside the tank instantly pushes in
the cylinder which leads to cylinder
explosion
Impurity of compressed air/air
source, which contains water and
stains etc.
Oil from cylinder has exceed the
STOP warning line, oil being
sucked through the vacuum tube
back to the vacuum generator.
poorly sealed
Connecters were poorly sealed.
precaution and solution
Extracting of uid that containing
corrosive liquid and oil additive.
gasoline, brake uid oil, synthetic/
half synthetic oil etc is strictly
prohibited to use for the machine.
Tighten or loosen cylinder
locking nuts with other tools is
strictly prohibited, please see the
operation manual and video
for the demount and change oil
cylinder.
Prohibit for oil extraction higher than
60°C
Handle with care, avoid hit and
knock
Always turn Off cylinder oil ejection
valve before oil draining
Filtered compress air before
connect to machine
Strictly follow the operational
manual and warning notice, waste
oil inside cylinder is NOT allow to
exceed the warning line.
Wrap PTFE thread seal tape in the
connecting part.
Replace of sealing ring.
Publicité
Table des Matières
