Philips Aqua Plus 8000 Serie Mode D'emploi page 14

English
14
Problem
The appliance has a lower
suction power than usual.
Too much water flows out
of the water tank at a too
high speed.
The floor dries with stripes
when I use the water tank.
Possible cause
The water tank is empty or
nearly empty.
You are using a microfiber
mopping pad that is not
supplied by Philips.
The air channels on the
Vacuum & Wipe nozzle are
blocked.
If too much water flows out of
the water tank at a too high
speed, the cap of the tank is
probably not closed properly.
The strip is not placed properly
in the bottom of the water
tank.
You added too much liquid
cleaner to the water.
The microfiber mopping pad is
not placed correctly and
creates stripes.
Solution
Refill the water tank.
Only use an original Philips microfiber
mopping pad. You can buy these mopping
pads in the online Philips shop at
www.shop.philips.com/service or at your
Philips dealer.
Open the lids of the air channels on both
sides of the tube on the Vacuum & Wipe
nozzle. Clean the channels (Fig. 11). Close
the lids and turn the nozzle upside down.
Clean the air channels from the bottom
(Fig. 12).
Check the cap and make sure it is fully and
properly closed.
Check the strip and make sure that it is
fitted properly in the bottom plate of the
water tank.
Use only a few drops of liquid cleaner or
use a cleaner that foams less.
Make sure that you place the mopping pad
correctly. Check the user manual for
proper placement.