Philips Aqua Plus 8000 Serie Mode D'emploi page 11

Signal Description of signal
Error code 'E7' lights up on the display.
Note: When the appliance is charging on the charging
station, the E7 error code may look like the
designation L3
Error code 'SE' lights up on the display.
Note: When the appliance is charging on the charging
station, the SE error code may look like the number
35.
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you are
unable to solve the problem with the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Center in your country.
Problem
The appliance does not
work when I push the slider.
The appliance suddenly
stops working.
The appliance has a lower
suction power than usual.
Possible cause
When the battery is empty, the
following icon flashes on the
display:
You have to push the slider
forward to switch on the
appliance.
When there is a problem, the
buttons will not respond and
the screen will remain blank.
The filter and the cyclone are
dirty.
Meaning of signal
The adapter may be defective. Please
contact the Consumer Care Center or
take the appliance to an authorized
Philips service center.
SE stands for service. Please take the
appliance to an authorized Philips
service center.
Solution
To charge the battery, connect the
appliance to the charging station or attach
the handheld vacuum cleaner directly to
the magnet on the charging station (Fig.
9).
Push the slider forward to setting 1 to
switch on the appliance. Increase the
suction power further by pushing the slider
to setting 2 or select the Turbo setting to
clean very dirty patches at the highest
suction power.
Connect the appliance to the charging
station or attach the handheld vacuum
cleaner directly to the magnet on the
charging station (Fig. 9). Check the display.
Once the appliance starts charging, you
may continue to use the appliance as
usual. If an error code appears, you can
find its meaning in this booklet (see 'User
interface signals and their meaning').
Empty the dust bucket. Clean the filter (Fig.
8) and the cyclone (Fig. 10). The filter light
lights up after several hours of use to
indicate that you have to wash the sponge
filter. Make sure that you wash the sponge
filter at least once a month if you use the
appliance regularly. Make sure that you
remove any hair and dirt that is stuck in the
cyclone.
English
11