BHG 720-0783DC Mode D'emploi page 15

Fig.15
8. Searing Side Burner Assembly
(a) Loosen (2) preinstalled Truss head screws
from left side of Firebox (A) as shown. Do not
screw out fully; leave ¼ extended for shelf
assembly. Through side burner shelf
keyholes, hang side burner shelf (N) on two
loosened screws. See Fig.16.
(b) Using (3) Truss head screws (AA), (3) Flat
washer (DD), attach side burner shelf to grill
head from inside the firebox. Insert (2) Truss
head screws (BB), (2) Flat washer (EE) attach
the side burner shelf front panel to the control
panel, see Fig.15. Fully tighten the two
loosened screws to secure shelf to firebox.
9. Searing Side Burner Valve Assembly
(a) Loosen the "C" bracket on the burner tube
located on the underside of the side shelf bowl
by removing the screw holding it in place. Turn
the "C" bracket so the opening of the side
burner tube is exposed.
(b) Remove the 2 screws that are pre-attached to
the valve. Insert the side burner valve into the
side burner control panel and bezel. Then align
the valve through the side burner panel opening,
making sure the orifice end is aligned in the
burner opening. See Fig.17.
(c) Slide the screws down to the smaller holes and
tighten the screws to secure. As shown in
Fig.18.
(d) Return to the underside of the side burner and
turn the "C" bracket to close the gap in the front
opening of the side burner tube. Tighten screw
to secure. See Fig.19.
Fig.16
A
N
Fig.17
15
Fig.14
S