Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.5
Installation recess
The refrigerator must be installed draught-free in a recess (see point "6.2").
The measurements of the recess are given in the table below.
Step (A) is only required for cabinets with a step. Push the appliance far enough into
the recess until the front edge of the refrigerator casing is flush with the front of the
recess. Allow a gap of 15-20mm [approx. 3/4"] between the back wall of the recess
and the refrigeration unit. The floor of the recess must be level, allowing the appliance
to be pushed easily into its correct position. The floor must be substantial enough to
bear the weight of the appliance.
Ensure that the refrigerator is installed level in the recess.
Recess measurements:
Model
RM 7401
RM 7551
Securing the refrigerator
6.6
Width of recess = W
Hight H
Width W
825mm
529mm
32-1/2"
20-17/20"
825 mm
529 mm
32-1/2"
20-17/20"
In the sidewalls of the refrigerator, there are four plastic
sleeves with screws for securing the refrigerator. The
sidewalls or rails attached for securing the refrigerator
must be designed in such a way that the screws will
remain firmly in place even when under increased load
(while the vehicle is moving).
Always insert screws through the sleeves provided;
otherwise, structural parts embedded in the foam,
such as cables, etc., may be damaged.
Once the refrigerator is in its final position, secure the
screws into the wall of the recess.
The screws must penetrate through the sheet metal
casing of the refrigerator.
22
Depth T
510 mm
20-1/4"
570 mm
22-9/20"
Publicité
Table des Matières
