Festo CPX-Terminal -P Mode D'emploi page 22

3.2 Mounting the module
Note
Incorrect handling can result in damage to the product.
• Observe the specified tightening torques.
• Make sure mounting surfaces are clean and that
seals are undamaged (sealing effect, prevention of
contact errors).
• Avoid mechanical stresses (tighten screws evenly in
diagonally opposite sequence).
Mounting the electronics module
1. Insert the electronics module correctly into the inter-
linking block.
2. Align the electronics module in such a way that the
grooves with the contact terminals on the underside of
the electronics module are positioned above the con-
tact rails.
3. Then push the electronics module carefully and
without tilting as far as possible into the interlinking
block.
Mounting the connection block
1. Check to make sure the mechanical coding of the con-
nection block is correct. If necessary, conduct a new
mechanical coding procedure (see section 3.1).
22 Festo CPX-P-EA 1209NH English