Argo POLIFEMO DEDALO Instructions D'utilisation page 18

TIMER/PRESET BUTTON
Timer off function: With the unit on, press this button to select the time of appliance turning off, each press of the button
allows you to set the shutdown interval from 1 to 15 hours, the LEDs on the control panel will light up based on your
selection. Once the selected interval is reached, the unit will turn off automatically. By holding down the Timer / Preset
button it is possible to speed up the setting of the Off Timer.
Preset function (On timer): In stand-by mode, press the Timer / Preset button to select the setting of the On timer of the
appliance, each time the button is pressed it is possible to set the on interval from 1 to 15 hours, the LEDs on the control
panel will light up according to your selection. Once the selected interval is reached, the unit will turn on automatically. By
holding down the Timer / Preset button you can speed up the setting of the On timer.
MODE BUTTON
When the unit is on, press this button to select the ventilation mode in the following sequence: General - Natural - Sleep,
the corresponding LEDs on the control panel will light up according to the selection made.
- General: The unit operates at a constant ventilation speed
- Natural: The unit works according to the factory settings, the ventilation speed changes automatically.
- Sleep: The ventilation speed decreases every hour until it reaches the minimum ventilation level
L&R SWING BUTTON
With the unit on, press this button to select the horizontal swing from right to left of the air flaps. The corresponding Swing
ON or Swing OFF LEDs will be lit on the control panel upon your selection.
HUMIDIFY BUTTON
With the unit turned on, press this button to activate or deactivate the humidification function. If this function is activated,
the corresponding LED on the control panel will light up.
Note: Before activating the humidification function, check the water level in the tank, which must be above the water level
indicator. If there is not enough water, add it to the tank.
LOW WATER LED
When the water in the tank is not enough to activate the humidification function, the Low Water LED flashes on the control
panel. Add water to the tank and activate the humidification function.
HALF LIGHT DISPLAY
When any selection on control panel are made for more than 40 seconds, the LEDs on the display reduce the light. To
reactivate them, press any of the buttons on the control panel.
MEMORY FUNCTION
This device is equipped with the Memory function, which allows you to memorize the selected settings after turning off the
unit. When the device is turned on, it will work with the previously memorized settings.
AUTO OFF FUNCTION
When the unit works for 15 consecutive hours and no selections are made on the control panel, the device automatically
switches off.
V 12/20
18