Maintenance And Storage - Argo POLIFEMO DEDALO Instructions D'utilisation

If you wish to keep the water in the tank below room temperature in order to maximize cooling in warmer months, leave the
two synthetic ice packs supplied in the freezer until solid, then add them to the water in the tank.
The ice will absorb heat from the water.
With the unit off, place the ice packs directly in the tank in the position shown in the figure below, inside the tank there is a
special space where to place the ice packs. Make sure that the tank can be pulled out normally.
We recommend continuous use of the ice for optimal cooling capacity.
Ice packs can be used repeatedly.
The first time it is used, you may detect a smell or the water may turn an unusual color: this does not constitute a health risk.

MAINTENANCE AND STORAGE

WARNING: ALWAYS UNPLUG THE APPLIANCE BEFORE CLEANING OR MAINTENANCE
PROCEDURES. IMPORTANT: DO NOT SUBMERGE THE PRODUCT IN WATER
Cleaning the outside surface of the appliance
Use a soft cloth to remove any dust from the product.
If this is not enough, use a soft cloth dampened with water and a mild detergent at a temperature not exceeding 50°C. Let the
appliance dry completely before using it.
Do not use corrosive detergents or solvents such as petrol. Do not wash the appliance with water. Do not use oils, chemical
substances or other items that may damage the surface to clean it.
Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
When the appliance is used for a long time, the tank, the tank filter, the honeycomb filter and the dust filter may have
accumulated dust, this could affect the air flow and the effect of cooling. It is therefore advisable to clean these parts every two
weeks.
Cleaning the dust filter and the honeycomb filter
Remove the filter assembly by detaching it from the unit by pressing on the opening hook. Once removed, gently remove the
honeycomb filter by sliding it under the hooks, remove the dust filter, always sliding it off the hooks, following the direction of
the guides. To assemble again, insert the dust filter in its holder and then insert the honeycomb filter (see Fig. 1)
Make sure all components are perfectly dry and properly installed to avoid damaging them.
V 12/20
20