Publicité
Les langues disponibles
Les langues disponibles
CP 1210, CP 1260, CP 1290
Breaking
Let the machine do the work; do not press too
♦
hard. The vibration-reducing handle must
absolutely not be pressed all the way down to the
base.
For pneumatic breakers with vibration-reducing
♦
handles: The feed force should be adapted so that
the handles are pressed down 'half way'. The best
vibration damping and breaking effect is achieved
at this position.
Avoid working in extremely hard materials for
♦
example granite and reinforcing iron (re-bar)
which would cause substantial vibrations.
Any form of idling, operating without insertion
♦
tool or operating with an uplifted machine must
be avoided.
When the machine is lifted, the start and stop
♦
device must not be activated.
Check regularly that the machine is well
♦
lubricated.
When taking a break
During all breaks you must place the machine in
♦
such a way that there is no risk for it to be
unintentionally started. Make sure to place the
machine on the ground, so that it can not fall.
♦
In the event of a longer break or when leaving the
workplace: Switch off the power supply and then
bleed the machine by activating the start and stop
device.
9800 1351 90 | Original instructions
*Always follow manufacturer instructions*
www.CrowderSupply.com • Toll Free: 888-883-5144
*AAA Rent-All 225-291-1356*
Safety and operating instructions
17
Publicité
