Publicité
Les langues disponibles
Les langues disponibles
Safety and operating instructions
Use the gauge that corresponds to the insertion
tool s shank dimension. See section "Technical data"
for correct tool shank dimensions.
>
Check if the gauge s hole (A) can be pushed down
on the insertion tool s shank, this means that the
shank is worn out and the insertion tool should
be replaced.
>
Check the length (B), that it is according to the
ordered machine type.
Fitting and removing the insertion tool
Whenever fitting or removing the insertion tool the
following instructions must be observed:
♦
To prevent an accidental start: switch off the air
supply and bleed the machine by pressing the
start and stop device. Disconnect the machine
from the power source.
♦
Before inserting a tool, lubricate the tool shank
with grease.
♦
Close the tool retainer and check the lock function
by tugging the inserted tool sharply outwards.
Operation
WARNING
Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
►
Learn how the machine is switched off in the event
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
16
*Always follow manufacturer instructions*
www.CrowderSupply.com • Toll Free: 888-883-5144
*AAA Rent-All 225-291-1356*
CP 1210, CP 1260, CP 1290
Start and stop
Start the pneumatic breaker by pressing down the
start and stop device.
Stop the pneumatic breaker by releasing the start
and stop device. The start and stop device will
automatically return to the stop position.
Operating
Starting a cut
♦
Stand in a stable position with your feet well away
from the inserted tool.
♦
Press the machine against the working surface
before you start.
Start collaring at such a distance from the edge
♦
that the machine is capable of breaking the
material without levering.
Never try to break off too large pieces. Adjust the
♦
breaking distance (A) so that the inserted tool
does not get stuck.
9800 1351 90 | Original instructions
A
Publicité
