Publicité
Les langues disponibles
Les langues disponibles
CP 1210, CP 1260, CP 1290
A
CP 1260, CP 1260 S, CP 1290 and CP 1290 S
B
CP 1260 SVR and CP 1290 SVR
Tighten the plug firmly and wipe off any excessive
♦
oil.
Insertion tool
CAUTION
Hot insertion tool
The tip of the insertion tool can become hot and
sharp when used. Touching it can lead to burns and
cuts.
►
Never touch a hot or sharp insertion tool.
Wait until the insertion tool has cooled down
►
before carrying out maintenance work.
NOTICE
Never cool a hot insertion tool in water,
it can result in brittleness and early failure.
Selecting the right insertion tool
Selecting the right insertion tool is a precondition
for proper machine function. It is important to select
insertion tools of high quality to avoid unnecessary
machine damage.
The machine can be destroyed if you use an incorrect
insertion tool.
Recommended insertion tools are listed in the
machine's spare parts list.
9800 1351 90 | Original instructions
*Always follow manufacturer instructions*
www.CrowderSupply.com • Toll Free: 888-883-5144
*AAA Rent-All 225-291-1356*
Safety and operating instructions
Narrow chisel
Moil point
Wide bladed chisel
WARNING
Vibration hazard
Using inserted tools that do not fulfil the criterias
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
Make sure that the inserted tool is
►
well-maintained, not worn out and of the proper
size.
►
Always use a sharp tool in order to work
efficiently.
Checking for wear on the tool shank
A
The narrow chisel is used for
demolition and cutting work in
concrete and other types of
hard materials.
The moil point is only used for
making holes in concrete and
other types of hard materials.
The wide bladed chisel is used
in soft materials, such as
asphalt and frozen ground.
B
15
Publicité
