Operating - Beko BKS 5316 T Mode D'emploi

4 Operating

4.1 Unwinding the cable
Unwind the cable completely. Yellow mark (mark
1) on the power cable indicates the recommended
cable length. Cable length should not go beyond
the red mark (mark 2). (Figure 4/1)
Figure 4/1
4.2 On/Off Button
1. Plug the cable to the power outlet.
2. Press on/off button on the vacuum cleaner to
start the product and press the button again to
turn it off.
4.3 Carpet cleaning
For carpet cleaning, press the feet button on the
floor head to take the brushes in.
4.4 Hard floor cleaning
To clean hard floors such as parquet, vinyl or
linoleum without scratching, change the position
of adjustment mechanism and clean with hair
brushes.
4.5 Re-Winding the cable
To re-wind the cable, press on the cable winder
button on the vacuum cleaner and direct the cable
with your hand. This will prevent the cable from
being thrown into the air and thus, causing harms
and injuries.
4.6 Carrying handle
Use the handle on the rear of the vacuum cleaner
to move it from one room to the other.
8 / EN
4.7 Parking vacuum cleaner:
You may park your vacuum cleaner horizontally.
You may park the product by installing the parking
apparatus on the back of the brush to the parking
slot on the rear of the product (Figure 4/2).
Figure 4/2
4.8 Accessories
1. You can directly attach the required accessory
to the handle firstly by removing the telescopic
tube.
2. Accessories can also be attached to the end of
the telescopic extension tube to reach further
points. Remove the floor head and attach the
desired accessories.
Crevice tool : For narrow places, corners and cracks
Upholstery nozzle : For carpet, flooring, stairs and etc.
Vacuum cleaner / User manual