Electrical Connection; Door Alignment - Wolf M Serie Instructions D'installation

Installation

Electrical Connection

The terminal block on the back of the range allows for a
3-wire or 4-wire installation. Remove the terminal block
cover to expose the screws with corresponding numbers.
Refer to the illustration below. Route the wires through the
strain relief and to the terminal block.
THREE-WIRE INSTALLATION
Connect green/ground to position one.
1
2 Connect red/L2 to position three.
Connect black/L1 to position four.
3
4 Tighten the screws on the strain relief and install the
terminal block cover.
FOUR-WIRE INSTALLATION
Connect green/ground to position one.
1
2 Connect red/L2 to position three.
Connect black/L1 to position four.
3
Install a wire nut on the white/neutral wire.
4
5 Tighten the screws on the strain relief and install the
terminal block cover.
6 5 4 3 2 1
Electrical connection

Door Alignment

To adjust door alignment, follow these steps:
1 Remove the skirt by extracting the screws.
Open the door, and loosen the nut. Refer to the
2
illustration below.
Close the door, and turn the screw clockwise to raise
3
and counterclockwise to lower the door.
Open the door, and tighten the nut.
4
5 Close the door, and reinstall the skirt.
ADJUSTMENT
SCREW
NUT
SKIRT
Door alignment
wolfappliance.com | 9