Anti-Tip Bracket - Wolf M Serie Instructions D'installation

Installation

Anti-Tip Bracket

To prevent the range from tipping forward, the anti-tip
bracket must be installed. To ensure the anti-tip bolt
engages the bracket, refer to the illustration below to
determine proper placement.
INSTALL BRACKET
Drywall application: After properly positioning the anti-tip
bracket, mark the holes, then use a Phillips screwdriver
or a low rpm power drill to drive the wall anchor into the
surface of the wallboard until flush. Pre-drill the holes if
needed. For hard wallboard or double-board construc-
tion, use a 1/4" drill bit. For solid plaster, use a 7/16" drill bit.
Use the provided #8 screws and flat washers to fasten the
bracket to the wall.
Wood floor application: After properly positioning the anti-
tip bracket, drill 3/16" pilot holes through the floor. Use
(5)
the provided #12 screws and flat washers to secure the
bracket to the floor.
Concrete floor application: After properly positioning
the anti-tip bracket, drill 3/8"
a minimum of 1 1/2" deep. Use the provided 3/8" wedge
(38)
anchors to secure the bracket to the floor.
ANTI-TIP
BRACKET
1
6 / "
4
(159)
Anti-tip bracket location
8 | Wolf Customer Care 800.222.7820
holes into the concrete
(10)
ANTI-TIP BOLT ADJUSTMENT
Once the bracket is secure, adjust the anti-tip bolt so the
top of the washer is 1 1/2"
(38)
Slide the range into the opening and verify the anti-tip bolt
is engaged. Refer to the illustration below.
1 7
1 / " –1 / "
2 (38) 8 (48)
Anti-tip bolt engaged
to 1 7/8" from the floor.
(48)