Bosch PMF 180 E Multi Notice Originale page 18

OBJ_BUCH-345-006.book Page 18 Wednesday, May 12, 2010 12:48 PM
18 | English
Mounting/Replacing the Application Tool/
Accessory
If required, remove an already mounted applica-
tion tool/accessory.
For removing the application tool/accessory
loosen the screw 9 with the allen key 10 and re-
move the tool.
Mount the application tool/accessory (e.g.
plunge cut saw blade 8) in such a way on the
tool holder 7 that the openings of the tool en-
gage into the cams of the tool holder.
For a safe and fatigue-free working position it is
possible to position the application tools/acces-
sories in any snap-in positions on the tool hold-
er. Position the tool in such a way that the de-
pressed centre points downwards (marking on
the tool is readable from above, see figure on
the graphics page).
Use the screw 9 to fasten the application tool/
accessory. Tightly fasten the screw 9 with the
allen key 10.
Check the tight seating of the application
tool/accessory. Incorrect or not securely fas-
tened application tools/accessories can come
loose during operation and pose a hazard.
Selecting the Sanding Sheet
Depending on the material to be worked and the required rate of material removal, different sanding
sheets are available:
Sanding disc Material
– All wooden materi-
als (e.g., hard-
wood, softwood,
chipboard, building
Red quality
board)
– Metal materials
– Paint
– Varnish
– Filling compound
– Filler
White quality
2 609 004 835 | (12.5.10)
Mounting/Replacing a Sanding Sheet on the
Sanding Plate
The sanding plate 11 is fitted with Velcro back-
ing for quick and easy fastening of sanding
sheets with Velcro adhesion.
Before attaching the sanding sheet 12, free the
Velcro backing of the sanding plate 11 from any
debris by tapping against it in order to enable
optimum adhesion.
Position the sanding sheet 12 flush alongside one
edge of the sanding plate 11, then lay the sanding
sheet onto the sanding plate and press firmly.
To ensure optimum dust extraction, pay atten-
tion that the punched holes in the sanding sheet
match with the holes in the sanding plate.
To remove the sanding sheet 12, grasp it at one of
the tips and pull it off from the sanding plate 11.
You can use all sanding sheets, fleece pads/pol-
ishing cloth pads of the Delta 93 mm series of
Bosch accessory program.
Sanding accessories, such as fleece pads/pol-
ishing cloth pads, are attached to the sanding
plate in the same manner.
Application
For coarse-sanding, e.g. of rough,
unplaned beams and boards
For face sanding and planing small
irregularities
For finish and fine sanding of wood
For sanding off paint
For sanding primer (e.g., for removing
brush dashes, drops of paint and paint
run)
For final sanding of primers before
coating
Grain size
coarse 40
60
medium 80
100
120
fine 180
240
320
400
coarse 40
60
medium 80
100
120
fine 180
240
320
Bosch Power Tools