Honeywell HCM-890 Serie Mode D'emploi page 3

SET UP
NOTE: We recommend that the humidifier be disinfected prior to first use. Please see CLEANING
instructions.
• Select a firm, level, flat location — at least six inches (15 cm) from any wall for proper air flow
(Fig. 1).
• Place the humidifier on a water-resistant surface, as water can damage furniture and some floor-
ing. Kaz USA, Inc. will not accept responsibility for property damage caused by water spillage.
FILLING
• Remove the water tank by grasping the handle and pulling straight
up (Fig. 1).
• Lift up on the Motor Housing to remove and set aside (Fig. 2).
Remove the cool moisture filter from the base before filling the
unit with water. Soak in a sink full of cool water to help reduce
mineral build up and place back in the humidifier while wet. DO
NOT SQUEEZE OR WRING OUT THE COOL MOISTURE FILTER. To
help extend the life of your filter repeat this step each time you fill
your humidifier.
• Turn the water tank upside down so that the fill cap is facing up;
unscrew the fill cap by turning it counter-clockwise
aside.
• Fill the water tank with COOL tap water (Fig. 3). Distilled water is
not necessary as the water is filtered by the cool moisture filter.
DO NOT USE HOT WATER. Doing so may damage the humidifier.
• Replace the fill cap by turning it clockwise
TIGHTEN. Turn the water tank right-side up.
NOTE: WHEN CARRYING THE FILLED WATER TANK, PLEASE USE
THE HANDLE AND PLACE YOUR OTHER HAND UNDER THE TANK
FOR ADDITIONAL SUPPORT.
• Place the Motor Housing back onto the Base.
• Once the filled tank has been positioned, do not attempt to move
the humidifier. If it has to be moved, unplug the humidifier and
remove the water tank first.
NOTE: DO NOT POUR WATER INTO THE GRILL ON THE TOP OF THE
MOTOR HOUSING. DOING SO MAY DAMAGE THE HUMIDIFIER OR
CAUSE PERSONAL INJURY.
All manuals and user guides at all-guides.com
. DO NOT OVER
Fig. 1
Fig. 2
and set
Lift
Fig. 3
6"
3