Table des Matières
Publicité
Settings
Display Rev
=
Rotation of the display
by 180°
Display
=
automatic display
switch-off
DMXFail
=
Operating status with
DMX signal interruption
Dim.Curve
=
Dimmer Curve
Dimmer Resp.
=
Dimmer response
White Balance
=
White balance
IR Remote
=
enables control via
IR remote control or
switch off
Factory Reset
=
Reset to factory
settings
ENTER
UP/DOWN
Display Rev On
Display Rev Off
Display On
Display Off
Hold
Blackout
Linear
Exp
Log
S-Curve
LED
Halogen
Red, Green, Blue, White
On
Off
Reset Now?
ENTER
UP/DOWN
ENTER
/
ENTER
UP/DOWN
ENTER
/
ENTER
UP/DOWN
ENTER
/
ENTER
UP/DOWN
ENTER
/
ENTER
UP/DOWN
ENTER
/
ENTER
UP/DOWN
ENTER
/
UP/ DOWN -ENTER
ENTER
UP/DOWN
ENTER
/
ENTER
ENTER = Yes /
MODE = No
Rotation of the display by 180° (e.g. overhead installation)
Normal display
= permanently on
= automatic switch-off of the display after 1 minute of inactivity.
= last command is held
= activates Blackout
= The light intensity increases linearly with the DMX value.
= Adjustment of the light intensity is finer in the lower DMX value
range and coarser in the upper DMX value range.
= Adjustment of the light intensity is coarser in the lower DMX
value range and finer in the upper DMX value range.
= Adjustment of the light intensity is finer in the lower and upper
DMX value ranges and coarser in the middle DMX value range.
= The spotlight responds abruptly to changes in the DMX value.
= The spot behaves in a manner similar to that of a halogen lamp
with gentle changes in brightness.
= Individual white balance. Cross-operating mode setting of the 4
RGBW LED groups
= enables control via IR remote control
= disables control via IR remote control
ENTER = Reset to factory setting
MODE = do not perform reset
/
/
ENTER
/
/
ENTER
/
/
ENTER
/
/
ENTER
ENTER
/
/
ENTER
/
/
/
/
ENTER
ENTER
UP/ DOWN -ENTER
UP/ DOWN -ENTER
/
/
ENTER
/
ENTER
/
/
ENTER
UP/ DOWN -ENTE
17
Publicité
Table des Matières
