Bosch GBH 18V-40 C Professional Notice Originale page 12

12 | English
Working mode (18) indic- Functions
ator
Auto working mode: Fast, controlled run-up up to maximum power
lights up
– "Hammer drilling" operating mode (Electronic Precision Control soft start): Fast, con-
– Rapid Shut-off (KickBack Control) active
– "Chiselling" operating mode (Adaptive Speed Control soft start): Fast, controlled run-up up
Favorite working mode: Individual configuration via smartphone app (only 3 611 J17 0..
lights up
in combination with the Bluetooth® Low Energy module GCY 42)
The following settings are preconfigured:
– "Hammer drilling" operating mode (Electronic Precision Control soft start): Controlled run-
– Rapid Shut-off (KickBack Control) active
– "Chiselling" operating mode (Adaptive Speed Control soft start): Fastest possible run-up
Soft working mode: Reduced power for processing sensitive materials
lights up
– "Hammer drilling" operating mode (Electronic Precision Control soft start): Slow, strictly
– Rapid Shut-off (KickBack Control) active
– "Chiselling" operating mode (Adaptive Speed Control soft start): Slow, strictly controlled
Connectivity functions
In conjunction with the Bluetooth® Low Energy Module
GCY 42, the following connectivity functions are available
for the power tool:
– Registration and personalisation
– Status check, output of warning messages
– General information and settings
– Management
Read the corresponding operating instructions for informa-
tion about the Bluetooth® Low Energy Module GCY 42.
Practical Advice
With the Bluetooth® Low Energy Module GCY 42, the
u
power tool is equipped with a radio interface. Local
operating restrictions, e.g. in aircraft or hospitals,
must be observed.
In areas in which the Bluetooth® wireless technology
u
must not be used, the Bluetooth® Low Energy Module
GCY 42 and the coin cell must be removed.
Note: The cover (15) can only be closed securely if the
Bluetooth® Low Energy Module GCY 42 and the coin cell are
in the power tool.
– To deactivate the Bluetooth® Low Energy Module
GCY 42, turn the coin cell over or place a means of insula-
tion between the coin cell and Bluetooth® Low Energy
Module GCY 42.
– Close the cover (15) to prevent dirt from getting in.
1 609 92A 88Y | (24.10.2022)
trolled run-up up to maximum power
to maximum power
up up to reduced, medium power
up to maximum power
controlled run-up up to reduced, low power
run-up up to reduced power
Overload clutch
u
u
Rapid shut-off (KickBack Control)
– To switch the tool back on, release the on/off switch (9)
Electronic Precision Control (EPC)
EPC assists you when drilling and when working with impact
in sensitive materials by ensuring slow start-up of the operat-
ing speed for precise working.
If the application tool jams or snags, the power trans-
mission to the drill spindle will be interrupted. Always
hold the power tool firmly with both hands to with-
stand the forces this may create and adopt a position
with stable footing.
Switch the power tool off immediately and remove the
application tool if the power tool becomes blocked.
Switching on when the drilling tool is blocked may
cause high torque reactions.
The rapid shut-off function (KickBack
Control) gives the user greater control
over the power tool and offers them bet-
ter protection than power tools that do
not have Kickback Control. If the power
tool suddenly and unforeseeably rotates
around the drilling axis, it will switch off,
the rapid shut-off indicator (17) will light
up red and the worklight (11) will flash.
When rapid shut-off is activated, the
status indicator (20) flashes red.
and then press it again.
Bosch Power Tools