Dometic GROUP Waeco CoolAir CA850S Notice De Montage page 35

Installation
6.3.4 Menu level 3: Operating mode
The unit always starts with a defined operating mode for room tempera-
ture. This parameter can be configured:
➤ Start configuration mode (see Chapter "Starting and ending configu-
ration mode" on page 33).
✓ The first digit of the display (fig. 7 on page 5, item 5) shows the menu
level and the second and third show the parameter which can be set.
➤ Press the + button (fig. 7 on page 5, item 6) twice to switch to menu
level 3.
➤ Press the Operating Mode button (fig. 7 on page 5, item 4) to
change the parameters.
✓ The digits in the display flash until the parameter you entered is
confirmed.
➤ Use the + and – buttons (fig. 7 on page 5, item 6 and 7) to set the
mode with which the unit starts up:
Characteristic fig-
ure
0
1
2
3
➤ Press the Operating Mode button (fig. 7 on page 5, item 4) to con-
firm your entry.
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 3 again and can use the + and – buttons to
switch between menu levels.
Operating mode
Automatic mode
Operating mode 1
Operating mode 2
Operating mode 3
CoolAir
35