Dometic GROUP Waeco CoolAir CA850S Notice De Montage page 30

CoolAir
6.2.1 Removing the sunroof
➤ Remove all screws and fixtures of the existing sunroof.
➤ Take out the sunroof.
➤ Remove the sealant around the opening, so that the surface is clean
and free of grease.
Note
I
Dispose of all waste material, glue, silicone and seals separately.
Observe the local disposal guidelines.
6.2.2 Preparing the unit
Note
I
During preparatory work on the surfaces, secure the unit from falling
down.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
➤ Place the air conditioning roof unit on a work surface with the housing
facing down.
Caution
a
Screw in the thread insert vertically.
Do not exceed the screw torque of 10 Nm.
➤ Screw in the 6 self-threading M8 thread inserts in the blind holes
marked with "2" (fig. 3 on page 4, item 1).
Use the supplied 1/4" bit for this.
6.2.3 Attaching the seal for the cab roof
Caution
a
Ensure that the adhesive surface for the seal between the unit and the
cab roof is clean (free of dust, oil, etc.).
➤ Stick the 2.5 m insulating tape (10 x 20 mm) to the cab roof, following
the outline of the sunroof opening (fig. 4 on page 4).
➤ Provide the abutting edge and the top edge of the insulating tape with
an unhardened plastic butyl sealing compound (e.g.
SikaLastomer-710).
30
Installation