Dometic GROUP Waeco CoolAir CA850S Notice De Montage page 32

CoolAir
You can connect the unit to the battery via the lorry's terminal block or
directly. The terminal block is to be preferred for the connection. Ask your
vehicle manufacturer for the specifications of the terminal block.
➤ Lay the supply line and connect it to the vehicle (red line to plus, black
line to minus).
➤ Plug in the supply line plug into the socket of the air conditioning roof
unit supply line.
➤ To relieve strain on the supply line, secure it with a cable tie, e.g to the
cab roof.
6.2.6 Fastening the cover frame
Caution
a
Screw the screws in carefully order not to damage the cover frame.
➤ Fasten the cover frame (fig. 6 on page 5, item 6) to the unit with the
four cylinder head screws (fig. 6 on page 5, item 8), washers (fig. 6
on page 5, item 7) and the four spacer sleeves L = 30 mm (fig. 6 on
page 5, item 5). The spacer sleeves keep the cover frame apart from
the unit.
6.3 Configuration of unit software
Before you first start up the unit, the controls can be adapted to suit the
installation conditions. This must be done by the person installing the unit.
In configuration mode, the following unit software parameters must be set
at the control panel (fig. 7 on page 5).
Menu
level
1
2
3
4
5
32
Parameter Meaning
Set temperature The unit starts at the temperature
defined here.
Low voltage The battery monitor shuts down the unit
cut-off at the voltage defined here.
Operating mode The unit starts with the operating mode
defined here.
Default settings Parameters 1 – 3 can be reset to the
default settings.
Temperature unit The temperature can be displayed in °C
display or °F.
Installation
Default
setting
20 °C
Characteris-
tic figure 4 =
22.8 V
0 = Auto-
matic mode
--
°C