Dometic GROUP Waeco CoolAir CA850S Notice De Montage page 33

Installation
Note
I
Configuration mode can still be activated if the undervoltage protection
mechanism has switched off the unit and only residual voltage is
available.
6.3.1 Starting and ending configuration mode
The adjustable parameters can be changed in configuration mode:
➤ When using the ON/OFF (fig. 7 on page 5, item 1) button to switch
on the unit, hold both buttons + and – (fig. 7 on page 5, item 6 and 7)
pressed until the compressor LED flashes.
✓ You are now in configuration mode.
✓ The first digit of the digital display (fig. 7 on page 5, item 5) shows
the menu level and the second and third digits show the parameters
which can be set, e.g.
17 °C.
Note
I
If you make no entry on the control panel for 60 seconds, the unit quits
configuration mode and shuts down.
➤ Press the ON/OFF button to quit configuration mode.
6.3.2 Menu level 1: Set temperature
The unit always starts with a defined value for the room temperature. This
parameter can be configured between 17 and 30 °C:
➤ Start configuration mode (see Chapter "Starting and ending configu-
ration mode" on page 33).
✓ The first digit of the display (fig. 7 on page 5, item 5) shows the menu
level and the second and third show the parameter which can be set.
➤ Press the Operating Mode button (fig. 7 on page 5, item 4) to
change the parameters.
➤ Use the + and – buttons (fig. 7 on page 5, item 6 and 7) to select the
target value (in °C) at which the unit should start operation.
✓ The digits in the display flash until the parameter you entered is
confirmed.
➤ Press the Operating Mode button (fig. 7 on page 5, item 4) to con-
firm your entry.
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 1 again and can use the + and – buttons to
switch between menu levels.
for menu level 1 and a set target value of
1.17
CoolAir
33