Black & Decker PRJE650 Mode D'emploi page 5

Assembly
1. Wash all detachable parts (see chapter
'Maintenance and cleaning').
2. Place the juice collector into the appliance
and place the pulp container into the
appliance.
3. Put the rotary sieve in the juice collector and
hold the lid over the rotary sieve and lower it
into position.
4. Make sure the rotary sieve is fitted securely
onto the driving shaft ('click').
5. Always check the rotary sieve before use. If
you detect any cracks or damage, do not use
the appliance and contact the nearest
service centre or take the appliance to your
dealer.
6. Lock the clamp onto the lid to lock it into
place ('click') and slide the pusher into the
feeding tube by aligning the groove in the
pusher with the small protrusion on the inside
of the feeding tube. Never insert your fingers
or an object into the feeding tube.
All manuals and user guides at all-guides.com
7. Place the juice jug under the spout.
8. Place the lid on the juice jug to avoid
Use
1. Place the appliance on a flat, stable surface
2. Select the required speed (l or ll) using the
3. Remove the pusher & add the ingredients,
While you are preparing juice, you can empty
the pulp container by switching the appliance off
and carefully removing the pulp container.
Note: Reassemble the empty pulp container
before you continue juicing.
4. When juicing is completed, return the control
The Juicer should not be run for longer than 2
Minutes. After each 2 Minutes use, the Juicer
should be allowed to cool for at least 1 minute or
until it reaches room temperature before further
use.
splattering or if you want to store the juice in
the refrigerator.
and connect it to the electrical supply.
rotary switch.
using the pusher to guide the ingredients
onto the blades.
to the O (off) position.
The appliance should be
disconnected from the mains supply
before removing
ENGLISH
5