State Of California Proposition 65 Warnings; Parts Supplied - Thermador HMIB40HS Mode D'emploi

Important Safety Instructions – Installation
Be sure your appliance is properly installed
and grounded by a qualified technician.
Installation, electrical connections and gro-
unding must comply with all applicable
codes.
WARNING – TO REDUCE THE RISK OF
FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
a) Installation work and electrical wiring
must be done by authorized person(s) in
accordance with all applicable codes
and standards, including fire-related
construction.
b) Sufficient air is needed for proper
combustion and exhausting of gases
through the flue (chimney) of fuel burning
equipment to prevent back drafting.
Follow the heating equipment
manufacturer's guideline and safety
standards such as those published by
the National Fired Protection Association
(NFPA), and the American Society for
Heating, Refrigeration and Air Conditio-
ning Engineers (ASHRAE), and the local
code authorities.
c) When cutting or drilling into wall or
ceiling, do not damage electrical wiring
and other hidden utilities.
d) Ducted fans must always be vented to
the outdoors.
Remove all tape and packaging before
using the appliance. Destroy the packaging
after unpacking the appliance.
Never allow children to play with packaging
material.

State of California Proposition 65 Warnings:

WARNING
This product can expose you to chemicals including vinyl chloride, which is known to the
State of California to cause cancer and birth defects or other reproductive harm. For
more information go to www.P65Warnings.ca.gov.
Parts Needed
K Tape Measure
K Phillips Head Screwdriver
K Duct Tape
K Ductwork (configuration varies depending
on location; see "Prior to installation").
K Additional Sheetmetal screws
(as necessary for ductwork installation)
4
Never modify or alter the construction of the
appliance. For example, do not remove
leveling legs, panels, wire covers or anti-tip
brackets/screws.
CAUTION – For general ventilating use only.
Do not use to exhaust hazardous or
explosive materials and vapors.
To reduce risk of fire and to properly exhaust
air, be sure to duct air outside. Do not vent
exhaust air into spaces within walls, ceilings,
attics, crawl spaces or garages.
WARNING – to reduce the risk of fire, use
only metal ductwork.
WARNING – The applicable regulations of
the energy supply companies and the
regional construction regulations must be
observed when installing the hood.
This appliance complies with one or more of
the following Standards:
UL 858, The Standard for the Safety of
Household Electric Ranges
UL 923, The Standard for the Safety of
Microwave Cooking Appliances
UL 507, The Standard for the Safety of
Electric Fans
ANSI Z21.1, The American National
Standard for Household Cooking Gas
Appliances
CAN/CSA-C22.2 No. 113-M1984 Fans and
Ventilators
CAN/CSA-C22.2 No. 61-M89 Household
Cooking Ranges
It is the responsibility of the owner and the
installer to determine if additional
requirements and/or standards apply to
specific installations.

Parts Supplied

K Appliance assembly (1)
K Sheetmetal Screws (6)
K Wood Screws (4)
K Counter Sink Screws (2)
K Hardware for brackets on vent (2)
K Plugs UX6 (6)