Wireless Communication; Commissioning And Operation - Waldbeck Kopernikus Mode D'emploi

Reset button and transmitter LED
You can reset the device by pressing the button (Reset) with the tip of a bent
paper clip: The LED lights up while the Reset button is pressed and you can
then release it. The LED will then flash every 48 seconds as before.

Wireless communication

Note: Attach the sensor to a vertical surface such as a wall to ensure good
communication. Do not lay it flat. Wireless communication depends on
interference, distance, walls and metal barriers. It is recommended that the
following instructions are followed to ensure flawless wireless communication.

COMMISSIONING AND OPERATION

Receiver/ Indoor unit
After inserting the batteries into the battery compartment, all elements
of the control panel light up for a few seconds to be checked. The Weather
Station will then take initial measurements and connect to the transmitter
(the corresponding icon will appear on the screen). Do not press any key until
the outdoor sensor has received the data, otherwise the outdoor sensor's
synchronization process will be automatically aborted. Once the outdoor
transmitter has been registered, the indoor unit switches to the normal display
mode, in which all further settings can be made. If no RCC signal is received
during the first setting, the transmitter will attempt to receive an RCC signal
once every two hours until the last RCC signal is received. The RCC icon is
displayed on the monitor. If the RCC signal is permanently unavailable for
more than 12 hours, the RCC icon no longer appears on the screen.
10
RESET-Taste
LED-Licht
EN
29