Installation - Waldbeck Kopernikus Mode D'emploi

1 Anemometer
2 Wind vane
3 Temperature and humidity meter
4 Rain gauge
5 Spirit level

INSTALLATION

Installation of the U-bolts and the metal plate
The installation of the U-bolts, which fix the sensor to a rod, first requires the
installation of the supplied metal plate to which the ends of the U-bolts can
be attached. The metal plate (see Figure 3) has four holes through which the
ends of the U-bolts fit. The metal plate itself is pushed into a groove on the
bottom of the unit. The metal plate has a straight edge that slides into the
groove and the other side is bent at a 90-degree angle for easier attachment
to the mounting rod. Once the metal plate is inserted, you can slide the U-bolts
through the holes in the metal plate (see Figure 3).
6 Aerial
7 U-bolt
8 Battery compartment
9 Reset
Led display: the light lights up for
4 seconds after switching on. The
10 led then flashes once every 48
seconds, indicating that data is
being transmitted (update period).
3
EN
25